Rebuild

When your machine is rebuilt by MTSU, our technicians are trained to restore it to its original condition. The existing control and electronics are maintained. We will disassemble the entire machine to the bare castings and all bearings and seals will be replaced with new. The machine’s way surfaces will be precision ground or machined to meet or exceed OEM specifications. All Turcite©/Rulon© will be replaced with new as required. The machine tool’s geometry will be restored to its original specifications. MTSU will recondition the spindle and/or bar to meet OEM specifications. Your machine will undergo a thorough inspection in the following areas: gears, shafts and major castings. Damage to gears, shafts and castings will be reported and can be repairs at an additional cost.

During the rebuild of your machine, our technicians will completely rebuild the lubrication system. It will be tested for performance and adequate oil flow. All meter units will be replaced with new. Damaged lube lines will be replaced with new. All hydraulic pumps will be rebuilt and tested for performance, pressure and flow. We will replace all hydraulic hoses. MTSU will inspect the ball screws and lead screws for wear. Ball screws and lead screws that show excessive wear will be reconditioned.

Our technicians will inspect and clean the magnetic panel along with all limit switches and pressure switches. Damaged Sealtite will be repaired or replaced. Our electrical technicians will take the time to disassemble each electrical motor for the purpose of cleaning and replacement of shaft bearings. If desired, the machine can be painted to colors specified by our customer.

Complete documentation is supplied with all machines that we rebuild. All rebuild work performed by MTSU carries a full one-year warranty on parts and labor.